U.S. Army Material Command (AMC) AMCP 706-210 — FUZES - Engineering Design Handbook AMCP 706-210 (U.S. Army) PDF Download

Downloaded from https://www.everyspec.com AMCP 706-210 P61ZOELIC?0I1 CAYST&L tact with the steel envelope. The envelope is grounded to tke projectile, thereby completing the circuit and allowing the energy in the piezoid to flow to the fuze. Electrical energy is stored in the )ie.oid by a unique reversal of piezo-strain. Setback forces, acting on the components in front of the piezoid (viz.' the fulcrum plate, shorting bar, ball sup- Fir 3port), generate a compressive strain within the Figure 3-5. Piezoelectric Base Element piezoid. This strain produces an electrical poten- tial between the piezoid surfaces.

As the setback of the energy delivered by the elemeit is dissi- forces approach a maximum value, setback de- pated in the detonator. Some protection against flects the shorting bar tang and makes contact prematures as well as decreased sensitivity to with the anvil through the slot provided in the light targets (such as 1/8-in, fir plywood) may be fulcrum plate, causing a short circuit between obtained by the use of a large air gap (in the or- the piezoid surfaces. The short reduces the po- der of 0.150 in.) in the circuit between Lhe ele- tential across the piezoid to zero while the pie- ment and the detonator. This ap is closed by the zoid is still strained.

When the setback forces force of impact with heavier targets. A small gap decrease, the shorting bar tang returns to its (in the order of 0.010 in.) may be used if a mate- original position, removing the short. The pie- rial with a suitable dielectric is added. Upon im- zoid is unstrained as setback decays to zero, pact with the target, sufficient energy must be generating a new potential of opposite polarity generated by the piezoelectric element to cause which is retained by the capacitance of the ele. electrical arcing through the dielectric permitting ment until the ball switch is closed. The ball normal functioning.

The use of a bleeder resistor switch was designed to function upon graze is recommended even with a spsrk gap, The impact and upon impacting soft targets that do' bleeder resistor should directly shunt the piezo- not crush the nose of the round. electric element and not include the spark gap in its circuit. 3-4.3.2 ElectromagnetIc Generators The Piezoelectric Control-Power Supply, XM22E4, is shown in Fig. 3-62 . It is the power Electromagnetic generators are divided into source for the XM539E4 Base Fuze of the two general types, rotated and sliding. Both of XM409 HEAT Cartridge.

The power supply, housed in the nose, was designed to supply the SHORTING BAR base element with an electrical charge at the prope- timc. The minimum charge is set at 300 FULCRUM PLATE B CALL SWITCH volts with 1000-picofarad capacitance. Basically, F:EZOIO \ \ SWITCH the power supply consists of a piezoelectric INSULATOR ceramic element and an inertia ball switch, both A-- contained vnth6 a steel envelope that is hermeti- cally sealed. The piezoid is held in an anvil that provides support during setback and also provides elctri- -" cal connection to the terminal pin. From the:e, a wire connects to the fuze in the base.

A fulcrum plate bers against the opposite face of the pi- ezoid and also acts as the other leg of the elec- TERMINAL trical connection that follows through the adja- cent parts and to the impact switch. Further electrical continuity is interrupted by the switch 1os In - insulator. Upon deceleration due to impact or graze function, the ball is driven forward, de- Figure 3.6. Piezoelectric Control-Power Supply, flecting the tarks of the switch, and making con- XM22E4 3-7