Downloaded from https://www.everyspec.com AMCP 7W210 Piaumwus ll \\PO 1111110"I Wa F921 MOW ADAPTER iU$s Z 1JW.ION AKSLY S.AUEY Figure 4-9. MDF Used in 37 mm Spotting Cartridge, XM415E7 4-4.5.4 Detonating Cord onates rearward to ignite the black powder ejec- tion charge through flash holes in the igniter Detonating cord consists of a small fabric or tube. The MDF continues to detonate rearward plastic tube filled with a high explosive, usually to ignite the PETN burster charge in the boom. PETN.
Detonating cord must be initiated by a The PETN burster charge functions before the high i~tensity shock wave; it in turn propagates ejection charge because the MDF has a faster a detonation wave along its entire length. reaction rate than the black powder. When the burster charge explodes, it blows off the boom 4-4.5.5 Mild Detonating Fuze with the fin and opens the rear end of the steel body. The black powder gradually builds up Mild Detonating Fuze (MDF) consists of a pressure, ejects the pyrotechnic mixture from column of high explosive material in a flexible the rear opening of the body, and ignites to metal sheath. Currently available MDF is made generate gray smoke.
with PETN as the explosive charge enclosed in a lead sheath. Experiments are underway with 4-5 CONSIDERATIONS IN EXPLOSIVE other shield materials and explosives' s. TRAIN DESIGN MDF is used mainly to transfer a detonation some distance away. It is available in charge 4-5.1 GENERAL weights from 1 to 20 grains of explosive charge per foot. Smaller izes of this material will trans- The explosive reactions employed in fuzes are mit a detonation with little disturbance to the usually started by relatively weak impulses. It is surroundings.
A minimum of protection is re- the purpose of the explosive train to amplify quired to prevent blast and fragments from caus- these impulses so that the main charge detonates ing damage. at its stable rate. As described above, this proc. A typical fuze application of MDF is shown in ess can encompass the following steps or proc- Fig. 4-9". Iite problem was to simulate the full. esses; initiation of a deflagration, acceleration of caliber Davy Crockett roand with boom and tail the deflagration so that shock waves are gen- fin in a subcaliber spotting round.
The figure er ted, establishment of a detonation, and propa- shows the 37 mm Spotting Cartridge XM415E7, ga on and growth n^ this detonation to its with Fuze, XM544E1. Operation is as follows: stable velocity. On impact, the fuze ignites an XM64 Detonator Normally, separate explosive components are tht ignites a lead cup assembly that in turn ig- used for most of these steps. If the projectile or nites the MDF in the igniter tube assembly (1/8 missile small enough, only one component in. inside diameter by 5 in. long). The MDF det- need be used. Larger projectiles have several 4.12