H8DCE-HTe User's Manual ports on computer systems use IRQ7 and I/O Port 378 as the standard setting. Select 278 to allow the parallel port to use 278 as its I/O port address. Select 3BC to allow the parallel port to use 3BC as its I/O port address. Parallel Port Mode Specify the parallel port mode. The options are Normal , Bi-directional, EPP and ECP. Parallel Port IRQ Select the IRQ (interrupt request) for the parallel port. The options are IRQ5 and IRQ7 . Chipset Confi guration NorthBridge Confi guration Memory Confi guration Memclock Mode This setting determines how the memory clock is set. Auto has the memory clock by code and Limit allows the user to set a standard value.
MCT Timing Mode Sets the timing mode for memory. Options are Auto and Manual. User Confi g Mode Options are Auto and Manual. Bank Interleaving Determines if memory will be interleaved. Options are Auto and Disabled. Burst Length Use this setting to set the memory burst length. 64-bit Dq must use 4 beats. Options are 8 beats, 4 beats and 2 beats. HardWare Memory Hole When "Enabled", allows software memory remapping around the memory hole. Options are Enabled and Disabled . Note: this is only supported by Rev E0 processors and above. 4-8