Burst EN In Gated Mode, the generator controls the waveform output according to the external signal level from the [FSK/Trig/Sync/Extmod] connector on the rear panel. Press [Burst] > Type softkey to select “ Gate ” and then press Polarity to set the gated polarity as "Positive" (or "Negative"). The generator outputs burst waveform only when the gated signal is "Positive" (or "Negative"). Figure 10.3 Gate Burst When the gated signal is "True", the generator outputs a continuous waveform; when the gated signal is "False", the generator completes the current period, and then stops and holds on the voltage level corresponding to the initial burst phase of the selected waveform.
For Noise waveform, the output will stop immediately once the gated signal becomes "False". Gated Burst could only be triggered by External trigger source. In addition, users can set the "Phase". 10.3 Burst Count Burst count is the number of carrier waveforms in one burst period. It is only available for N Cycle Burst mode (internal, external, or manually trigger sources). For internal trigger source, Burst period ≥ 1μs + Carrier Waveform Period Ч Burst Count. Press [Burst] > Type softkey to select “ N Cycle ”. The “Count” parameter is highlighted and is editable. And use the numeric keypad or direction keys and the knob to input the desired count.
The default is 1 and the settable range is 1 to 2000 000 000. This menu will be grayed out and disabled when the burst type is set to Infinite cycle or Gated. 10.4 Burst Period Burst period is the time from the start of one burst to the start of next burst. It is only Copyright © Qingdao Hantek Electronics Co., LTD HDG3000C User manual 65