Removing the Electronics Bay Required Tools • 5 ⁄ 16 ” nut driver or standard screwdriver. Hardware • 10-32 x 1 ⁄ 2 ” slotted screws (x8) Removing the electronics bay 1. Remove the top panel. See “Removing the top panel” on page 161 2. Remove the side panels. See “Removing the side panels” on page 162 3. Remove the upper electronics bay cover. See “Removing the upper elec- tronics bay cover” on page 173 4. Touch the metal plate of the electronics bay cover to discharge any static electricity. 5. Disconnect the 6 I/O card cables by pressing down on the long tabs and pulling out. See Figure 83. 6. Disconnect the chamber thermocouple wire. See Figure 83. Figure 83:
I/O card cable locations I/O Card cable locations Chamber thermocouple wire location 7. Remove the left and right side electronics bay mounting screws with a 5 ⁄ 16 ” nut driver or standard screwdriver. See Figure 84. -175