HP — Installing the electronics bay

Figure 84: Electronics Bay mounting screw locations Remove the 4 right side mounting screws Remove the 4 left side mounting screws 8. Slide the electronics bay out 3 inches (76mm) and disconnect the cables from the rear of the power distribution board. See Figure 85. Figure 85: Power distribution board rear cable locations PDB rear cable locations 9. To remove, slide the entire electronics bay out from the back of the printer. Installing the electronics bay 1. Slide the electronics bay into position, leaving 3 inches (76mm). 2. Connect the 4 rear power distribution board cables. 3. Slide the electronics bay back into position 4.

Using a 5 ⁄ 16 ” nut driver or standard screwdriver, reinstall the 4 left and 4 right side mounting screws. 5. Connect the I/O card cables. 6. Reinstall the upper electronics bay cover. See “Installing the upper elec- tronics bay cover” on page 174 7. Reinstall the side panels. See “Installing the side panels” on page 164 8. Reinstall the top panel. See “Installing the top panel” on page 162 -176