HP — Removing the electronics bay cooling fan

Electronics Bay Cooling Fan Required Tools • 5 ⁄ 16 ” nut driver or standard screwdriver. • 5 ⁄ 64 ” allen wrench. Hardware • 6-32 x 1 Ѕ ” flat head cap screws (x4) Removing the electronics bay cooling fan 1. Remove the top panel. See “Removing the top panel” on page 161 2. Remove the side panels. See “Removing the side panels” on page 162 3. Open the Electronics Bay. See “Opening the electronics bay” on page 171 4. Touch the metal plate of the electronics bay cover to discharge any static electricity. 5. Disconnect the P1 cable from the fan. See Figure 86. Figure 86: Electronics bay cooling fan connector location P1 Connector 6. Using a 5 ⁄ 64 ” allen wrench, remove the 4 mounting screws.

See Figure 87. -177