HP — Removing the umbilical cable

Umbilical Cable Required Tools • 5 ⁄ 16 ” nut driver or standard screwdriver • Cutters • 1 ⁄ 4 ” nut driver • 5 ⁄ 32 ” allen wrench Removing the umbilical cable 1. Remove the top panel. See “Removing the top panel” on page 161 2. Remove the side panels. See “Removing the side panels” on page 162 3. Remove the upper electronics bay cover. See “Removing the upper elec- tronics bay cover” on page 173 4. Remove the umbilical hose. See “Removing the umbilical hose” on page 241 5. Disconnect the umbilical cable from the I/O card. See Figure 193. Figure 193: Umbilical cable connector locations Disconnect the 2 umbilical cables from the I/O card 6.

Disconnect the umbilical cable from the head board by pressing in on the tab and pulling upward. See Figure 194. -247