HP — Installing the umbilical cable

Figure 194: Head board connector location Disconnect the umbilical cable 7. Disconnect the umbilical cable from the TC Amp board by pressing in on the tab and pulling outward. See Figure 195. Figure 195: TC Amp connector location Disconnect the umbilical cable 8. Feed the umbilical cable out through the energy chain. Installing the umbilical cable 1. Feed the umbilical cable through the energy chain. 2. Reconnect the umbilical cable to the TC Amp board. 3. Reconnect the umbilical cable to the head board. 4. Reconnect the umbilical cable to the I/O card. 5. Reinstall the umbilical hose. See “Installing the umbilical hose” on page 245 6. Reinstall the upper electronics bay cover.

See “Installing the upper elec- tronics bay cover” on page 174 7. Reinstall the side panels. See “Installing the side panels” on page 164 8. Reinstall the top panel. See “Installing the top panel” on page 162 -248