HP — Removing the Y EOT sensor

Figure 197: Y home sensor mounting screw location Remove the mounting screw 4. Remove the Y home sensor. Installing the Y Home Sensor 1. Align the Y Home Sensor with the mounting hole. 2. Using a 1 ⁄ 4 ” nut driver or standard screwdriver, reinstall the mounting screw. 3. Reconnect the Y Home cable. 4. Install the top panel. See “Installing the top panel” on page 162 Y EOT (End of Travel) Sensor Required Tools • 1 ⁄ 4 ” nut driver or standard screwdriver. Hardware • 6-32 x 3 ⁄ 8 ” slotted screw (x1) Removing the Y EOT sensor 1. Remove the top panel. See “Removing the top panel” on page 161 2. Disconnect the Y EOT cable by pressing in on the tab and pulling out- ward. See Figure 198. -250