X Motor Required Tools • 5 ⁄ 16 ” nut driver or standard screwdriver. • 1 ⁄ 2 ” box wrench. • 3 ⁄ 32 ” allen wrench. • 1 ⁄ 8 ” allen wrench. • Cutters. Hardware • Wire tie • 10-32 x 3 ⁄ 8 ” slotted screws (x16) • 10-32 x 1 ⁄ 2 ” slotted screws (x4) • 8-32 x 1 ⁄ 2 ” socket head cap screws (x4) Removing the X motor 1. Remove the top panel. See “Removing the top panel” on page 161 2. Remove the side panels. See “Removing the side panels” on page 162 3. Using a 5 ⁄ 16 ” nut driver or standard screwdriver, remove the 7 left side access panel mounting screws and remove the left side access panel. See Figure 200. -252