HP — Installing the XY table

Installing the XY table 1. Insert the zero gauge block into the gauge. See Figure 261. 2. Loosen the adjustment screw and slide the dial indicator assembly up or down to set the ‘zero’ reading: The large hand should be on 0 and the small hand on 5. 3. Tighten the adjustment screw (do not over tighten the screw) and recheck the reading. 4. Remove the zero block gauge block from the fixture. Figure 261: Tension gauge zero setting Adjustment screw Zero gauge block 5. Position the dial indicator on the top section of the Y-Drive belt at the center point of the belt. See Figure 262. Figure 262: Y-Drive Belt Tension Check Dial Indicator position for Y- Drive belt tension check.

Y-Drive Belt clamp (one on each side). -291