Figure 279: Umbilical hose wire tie location Reinstall wire tie 82. Align the left side access panel with the mounting holes. 83. Using a 5 ⁄ 16 ” nut driver, reinstall the 7 left side access panel mounting screws. 84. Align the right side access panel with the mounting holes. 85. Using a 5 ⁄ 16 ” nut driver, reinstall the 7 right side access panel mounting screws. 86. Reinstall the front cover. See “Installing the front panel” on page 168 87. Reinstall the side panels. See “Installing the side panels” on page 164 88. Reinstall the top panel. See “Installing the top panel” on page 162 89. Power up the printer. 91. Perform Z calibration. See “Z Calibration” on page 338 90.
From the display panel press Maintenance > Machine > Tips. 92. Perform XY Offset calibration. See “XY Tip Calibration” on page 340 93. Perform Part Based calibration. See “Performing part based calibration for HP Designjet 3D with the HP Designjet 3D Diagnostic Software” on page 352 . -303