Figure 281: Z home sensor mounting screw location Remove mounting screw 5. Remove the Z home sensor. Installing the Z home sensor 1. Align the Z home sensor with the mounting hole. 2. Reinstall the mounting screw with a 1/4” nut driver or standard screw- driver. 3. Reconnect the Z home cable. 4. Close the chamber door. Z EOT (End of Travel) Sensor Required Tools • 1 ⁄ 4 ” nut driver or standard screwdriver. Hardware • 6-32 x 3 ⁄ 8 ” slotted screw (x1) Removing the Z EOT sensor 1. Open the chamber door. 2. Raise the Z stage all of the way up. 3. Disconnect the Z EOT sensor cable by pressing in on the tab and pulling outward. See Figure 282. -305