• Z Guide rod spacer (x2) • Head bracket, dial indicator and belt tension gauge assembly • Z guide rod alignment fixture Hardware • 10-32 x 1 ⁄ 2 ” slotted screws (x4) Removing the Z stage 2. Remove the side panels. See “Removing the side panels” on page 162 1. Remove the top panel. See “Removing the top panel” on page 161 3. Remove the electronics bay. See “Removing the electronics bay” on page 175 4. Remove the Z motor. See “Removing the Z motor” on page 321 5. Tilt the printer forward 6 inches (152mm) and prop up with a material carrier or something similar. -326