6. Using a 5 ⁄ 16 ” socket driver or 5 ⁄ 16 ” box wrench, remove the 2 lower Z stage guide rod mounting screws. See Figure 308. Figure 308: Lower Z stage guide rod mounting screw locations Remove the 2 mounting screws 7. Using a 5 ⁄ 16 ” nut driver or standard screwdriver, remove the 2 upper Z stage guide rod mounting screws. See Figure 309. Figure 309: Upper Z stage guide rod mounting screw locations Remove the 2 mounting screws 8. Remove the Z stage by pulling out of the printer through the chamber door. Installing the Z stage 1. Align the Z stage guide rods with the upper and lower mounting holes. 2.
Using a 5 ⁄ 16 ” socket driver or 5 ⁄ 16 ” box wrench, loosely fasten the lower Z stage guide rod mounting screws. 3. Using a 5/6” nut driver or standard screwdriver, loosely fasten the upper Z stage guide rod mounting screws. -327