19. Lower the Z stage to the bottom. 20. Insert the Z stage leadscrew alignment fixture at the top of the guide rods. See Figure 313. 21. Once the alignment fixture is in properly, turn the locking screws 1 ⁄ 4 turn counter clockwise to lock in place. See Figure 313. Figure 313: Inserting the Z stage leadscrew alignment fixture 22. Using a 5 ⁄ 16 ” nut driver or standard screwdriver, securely fasten the upper Z stage leadscrew mounting bracket screws. 23. Remove the Z stage leadscrew alignment fixture by pressing in the screws and turning 1/4 turn clockwise to unlock. 24. Move the Z stage to its lower limit. 25. Using a 3 ⁄ 32 ” allen wrench, securely fasten the Z motor mounting screws. 26.
Using a 5 ⁄ 16 ” nut driver or standard screwdriver, reinstall the Z stage panel. 27. Slowly lift the Z stage to the top of its travel, making sure it has smooth movement. 28. Let the Z stage travel to the lower limit on its own or with slight down- ward pressure, making sure it has smooth movement to the end of travel. Note: If the Z stage is binding, loosen the Z stage motor mounting screws and the Z stage leadscrew mounting bracket screws, then repeat steps 10-24. -330