Tera Term Commands Tera Term is an easy way to check and troubleshoot the hardware of a machine. Here are a couple of helpful commands which can be used to operate the machine through Tera Term. All values, which are displayed in Tera Term, are in inches. For some commands, the machine must find Home position before you can enter commands. Type help (space) command and press Enter for command information. NOTE: For a list of commands type help and press Enter . Example = help fh 1. trace c commandDetails on This command enables the printer information to be displayed in the Tera Term window. 2. fh = Find Home. This command determines the XY axis home position.
It locates the X and Y axis limit switches, sets the origin, and places the head over the purge bucket. Used for testing X/Y limit sensors. During boot-up process; a bad sensor could leave the machine stuck in initializing, fh will help find the right sensor. Example= fh The values which are displayed are explained below, see Figure 439 Figure 439: Find Home -434 Setting Gantry Type: During the home sequence, the machine is also looking at which table is installed in the machine (cable drive or Belt drive). GR5K means, the Gear Ratio is 5000 microsteps/inch.