omron — Replacing the Drive Shaft Bushings

Chapter 7: Maintenance Motor fans run for about 1 minute before shutting off. (If the robot is hot, they will con- tinue to run.) 4. Verify that the J3 motor fan is running by looking through the Status Display opening. 5. Re-install the Status Display panel with the four M4 bolts previously removed. l Apply Loctite 222 in each bolt hole, not on the bolts themselves. l Ensure that the Status Display panel gasket is in place between the panel and the robot body. l Torque the bolts to 1.1 N·m (10 in-lb). 7.8 Theta Drive Shaft NOTE : The fixed platform Hornet 565 does not use a theta drive shaft, so the fol- lowing procedures do not apply to those robots.

Replacing the Drive Shaft Bushings The bushings in the drive shaft are a normal wear item, and need to be replaced yearly or every 5,000 hours of use. A bushing replacement kit is available as p/n 15005-000. Figure 7-4. Drive Shaft Bushing Replacement Kit 1. Remove power from the Hornet. 2. Disconnect the lower U-joint from the drive shaft. Do not disconnect the upper U-joint. Hornet 565 Robot User's Guide, 14608-000 Rev C Page 107 of 156