omron — Removing the Drive Shaft

Chapter 7: Maintenance shaft. 8. Replace the old bushings with the three new bushings from the rebuild kit. 9. Insert the center shaft, fixture end first, into the drive shaft cylinder. l The top end cap of the cylinder and the bottom end of the center shaft each have a hole that a U-joint attaches to. Make sure that those two holes are parallel with each other when you insert the center shaft into the cylinder. l The three sets of five screws down the length of the drive shaft cylinder hold three guides that the bushings slide over. You will need to “feel” for the bushings lining up with their guides inside the cylinder. 10.

Slide the replacement bottom end cap over the end of the center shaft. Figure 7-6. End Cap Placed Over Center Shaft 11. Slide the end cap into the end of the drive shaft cylinder, so that the three holes in the cylinder align with the holes in the end cap. 12. Screw the three screws previously removed through the cylinder and into the end cap. Use Loctite 242 on the screws. 13. Reattach the lower U-joint to the platform, using the dog point set screw previously removed. Use Loctite 242 on the set screw. Removing the Drive Shaft The theta drive shaft has a U-joint on each of its ends. One connects to the J4 motor drive, the other connects to a shaft on the top of the J4 platform.

l Disconnect the bottom U-joint from the shaft on top of the J4 platform. l Disconnect the top U-joint from the drive shaft of the J4 motor. Hornet 565 Robot User's Guide, 14608-000 Rev C Page 109 of 156