Chapter 7: Maintenance To remove a U-joint from a J4 motor or platform shaft: 1. Unscrew the M6 x 20 dog point set screw that goes through the U-joint and shaft. Theta Drive Shaft For the top U-joint, use a 3 mm hex key, with a 10 - 15 mm short leg. There is not enough room at the J4 motor shaft to use a standard hex key. U-Joint 3 mm Set Screw 10 - 15 mm J4 Shaft (Motor or Platform) Figure 7-7. Short 3 mm Hex Key (Above), U-Joint (Right) The set screw was put in with Loctite 242. Save the set screw for installing the replacement drive shaft. 2. Slide the end of the U-joint off of the J4 motor or platform shaft. The fit will be fairly tight.
Installing a Drive Shaft When the theta drive shaft is shipped, it will have one end of a U-joint attached to each end. Hornet 565 Robot User's Guide, 14608-000 Rev C Page 110 of 156