omron — Aligning the Platform and J4 Motor

Chapter 7: Maintenance NOTE : The drive shaft has a top and bottom. Installing it upside-down will degrade system performance. Look for a “Top” label on the drive shaft. Upper U-Joint at J4 Motor The larger cylinder section goes at the top. l Attach the top U-joint to the drive shaft of the J4 motor. The top (J4 motor) end of the drive shaft is labeled with a temporary label, indicating Top. Remove the label before use. See figure at right. CylinderSection of Drive Shaft l Attach the bottom U-joint to the shaft on top of the J4 To attach the free end of a U-joint: platform. 1. Slide the free end of the U-joint over the J4 motor or plat- form shaft. The fit will be fairly tight.

Center Section of Drive Shaft The hole in the side of the U-joint needs to line up with the hole in the shaft. 2. Insert one of the M6 x 20 dog point set screws pre- Lower U-Joint at J4 Platform viously removed through the hole in the side of the U- joint, screw it through the shaft, and into the blind hole on the opposite side of the U-joint. The shafts are threaded, the U-joints are not. l Use Loctite 242. l Tighten to 5 N-m (3.7 ft-lbf) of torque. The head of the set screw should be flush with the outer surface of the U-joint.

Aligning the Platform and J4 Motor It is possible for either the motor shaft or the platform shaft to be turned, manually, before the theta drive shaft is connected to both. If not detected, the software may assume the robot’s tool flange is at a different angle than it really is. To ensure that the software knows the actual rota- tion of the tool flange with respect to the J4 motor, you need to use the ACE software to estab- lish this alignment. 1. Within the ACE software, open the Hornet565 robot object. 2. In the Configure tab, click Adjust J4 Zero. This will launch a utility for aligning the theta drive shaft. 3. Follow the instructions in the utility.

Contact Omron Adept Technologies, Inc. for more information on this procedure. NOTE : Once the theta drive shaft is installed, the J4 motor and the tool flange will always rotate together, so the software will know the orientation of the tool flange. Hornet 565 Robot User's Guide, 14608-000 Rev C Page 111 of 156