Chapter 7: Maintenance Figure 7-8. Status Display Panel Face 9. Remove but do not disconnect the Status Display panel. Retain the Status Display panel and gasket for re-installation. NOTE: The battery pack is supported in a bracket that is attached to the back side of the Status Display panel with stand-offs. The battery pack is exposed when the Status Display panel is removed. 10. The battery bracket assembly has two battery connectors. Locate the unused battery con- nector on the battery bracket. See the following figure. CAUTION: If battery power is removed from the robot, fact- ory calibration data may be lost, requiring robot recal- ibration by Omron Adept Technologies, Inc. personnel.
11. Connect the new battery pack to the unused connector on the battery bracket, but do not disconnect the old battery pack yet. There is only one way to plug in the connector. Hornet 565 Robot User's Guide, 14608-000 Rev C Page 113 of 156