omron — 7.11 Changing the Front Panel High-Power Indicator Lamp

Chapter 7: Maintenance 7.10 7.11 Hornet 565 Robot User's Guide, 14608-000 Rev C Page 115 of 156 on-Periodic Maintenance Item Estimated Time of Maintenance Description Front Panel Lamp 30 Minutes Lamp can burn out over time. Platform 30 Minutes Excessive wear, gritty environment, damage from accidental impact. Ball Joint Inserts 45 Minutes Plastic inserts can be replaced in case of excessive wear. Pre- ferred solution is to stock and swap extra outer arms. Springs and Horseshoes 15 Minutes Springs and horseshoes can be replaced in case of excessive wear or accidental breakage. Preferred solution is to stock and swap outer arms. Outer Arms 15 Minutes Broken by accidental impact.

Sold in pairs with springs, horse- shoes, and inserts. eAIB 1 Hour Accumulated wear on electronics by excessive operations or poor line voltage. hanging the Front Panel High-Power Indicator Lamp The system is equipped with circuitry to detect the potentially dangerous condition of a burned-out High Power indicator on the Front Panel. If this lamp is burned out, you cannot enable high power until the lamp has been replaced. Follow this procedure to replace the High Power indicator lamp. The part number for the lamp is 27400-29006. WARNING: Lockout and tagout power before servicing. WARNING:

The procedures and replacement of parts mentioned in this section should be performed only by trained, authorized per- sonnel. The access covers on the Front Panel are not interlocked - turn off and disconnect power before removing the cover. 1. Turn off system power to the robot. 2. Turn off power to the optional SmartController EX, if you are using one. 3. Disconnect the cable between the Front Panel and the eAIB (or controller). 4. Remove the Front Panel from its mounting location. Save the mounting hardware for re-installation. 5. Remove the two screws on the back of the Front Panel. Save the screws for re-installation. 6.

Carefully pull the front cover away from the body of the Front Panel.