4.3 The Drive and Programming Modes The following actions are possible in the Drive Mode: • Run and stop the drive. • Monitor the operation status of the drive (frequency reference, output frequency, output current, output voltage, etc.). • View information on an alarm. Note: Select "Drive Mode" when running. The mode can be switched to any mode (program mode, etc.) other than drive mode while the drive is stopped. However, the drive cannot be operated in other modes. Return the mode to "Drive Mode" after completing periodic inspection. Figure 4.4 illustrates changing the default frequency reference of F 0.00 (0 Hz) to F 6.00 (6 Hz) while in Drive Mode.
This example assumes the drive is set to LOCAL. Frequency reference display at power up STOP Press to select LOCAL Press to select the digit to the right Press until the frequency reference becomes 6 Hz Figure 4.4 Setting the Frequency Reference while in Drive Mode Note: The drive will not accept a frequency reference set value unless the ENTER key is pressed after the frequency reference is entered. This feature prevents accidental setting of the frequency reference. By setting o2-05 (Frequency Reference Setting Method Selection) to 1 (Enabled), the drive will accept the frequency reference while it is being adjusted on the digital operator.
n Programming Mode Details The following actions are possible in the programming mode: • Verify Function: Verify parameter setting changes from original default values. • Setup Group: Access a list of commonly used parameters to simplify setup. • Parameter Setting Mode: Access and edit all parameter settings. 58 SIEP C710606 33A OYMC AC Drive – J1000 User Manual Drive Mode Output Voltage Reference Monitors the output voltage of the drive. Monitor Display Monitor parameters (U parameters) are displayed. Programming Mode Verify F unction Lists all parameters that have been edited or changed from default settings. Refer to Verifying Parameter Changes: Verify Menu on page 59.
Set up A select list of parameters necessary to get the drive operational quickly. Refer to Parameter Setting The Setup Group within the Programming Mode on page 59. Allows the user to access and edit all parameter settings. Refer to Parameter List Frequency Reference on page 169. Drive Mode n Drive Mode Details Returns to the frequency reference display screen.