L-6534VW Operation Guide Maintenance This completes this section. Cleaning the ionizer when an error occurs If the needles on the ionizer are still dirty even after cleaning with the nylon brush, an error caused by an unexpected electrical discharge may occur. Clean the part where the error occurred. A: Ionizer above the unwinder axis A Display the Periodic Maintenance screen on the touch panel, and then switch to Feed section mode. (1) Press Periodic Maintenance from the Maintenance menu. (2) Press Switch Mode , select Feed section , and then press OK . B Open the unwinder roll cover on the press.
C Dampen the cleaning stick in the alcohol for cleaning the rollers, and then squeeze it lightly. c Important: Do not drip the alcohol for cleaning rollers directly on the ionizer. 294 A: Ionizer above the unwinder axis (depending on the model) U “A: Ionizer above the unwinder axis” on page 294 B: Unwinder side ionizer U “B: Unwinder side ionizer” on page 295 C: Ionizer in front of the drum U “C: Ionizer in front of the drum” on page 298