L-6534VW Operation Guide Troubleshooting When Nozzle Overlap is set to Customized The basic steps for this procedure are the same as when Nozzle Overlap is set to Standard. U “When Nozzle Overlap is set to Standard ” on page 387 A From the Preset Management menu - For Printing tab, select the Preset for Printing you used for printing, and then press Edit . B Select Nozzle Overlap , and then press Edit . C Select Customized , and then press OK . D Make a test print to identify the color of the streaks. If there are Wh or Dv streaks, proceed to the next step.
If the streaks are noticeable in a specific color, use the pattern for determining the color to be adjusted to identify the color of the streaks. See step 9 in the following section for details on how to identify the color of the streaks. U “When Nozzle Overlap is set to Standard ” on page 387 E Select (Subs) Head Stitch Adjustment or (Wh) Head Stitch Adjustment , and then press Edit . If you find any streaks on printout on the substrate, adjust using (Subs) Head Stitch Adjustment . If you find any streaks on printout of surface white + color printing with this press, adjust using (Wh) Head Stitch Adjustment . (You can only adjust color inks.
Also, this may be disabled depending on the print application software.) If you find any streaks on printout on the substrate where white ink is partly printed when printing onto the substrate and white ink, adjust using both (Subs) Head Stitch Adjustment and (Wh) Head Stitch Adjustment . 392