EPSON — "Manually specify the last eye mark" is displayed when you resume printing after pausing

L-6534VW Operation Guide FAQ B See steps 4 to 18 in “Replacing the Unwinder Side Substrate” on page 99 to replace the substrate. c Important: ❏ The print position shifts when you replace the substrate from the Change Substrate screen. Do not press Change Substrate on the Substrate Settings menu. ❏ Do not move the paper edge sensor. C Follow the instructions in the error message to clear the error. D Press the Start switch to restart printing. "Manually specify the last eye mark" is displayed when you resume printing after pausing A.

You need to align the eye marks when you resume printing after printing has been paused for some time, or if the amount of substrate fed manually exceeds the maximum limit. When printing has been paused for more than one hour, and when more than 5 m of substrate has been fed manually while printing is paused, expansion and contraction of the substrate can cause the eye mark pitch to expand and contract which generates a print position shift error; this can cause printing to resume in the wrong position. When "Manually specify the last eye mark" is displayed when you resume printing, follow the steps below. A Press Yes on the screen displayed.

The press starts feeding the substrate and sends the last eye mark to just before the eye mark sensor. Note: When you press No , printing resumes without aligning the eye marks, which can cause errors such as printing to overlap on the page just before printing paused, and margins to be entered between pages. B When "Specify the last eye mark." is displayed, open the top front cover on the press.is displayed, open the top front cover on the press. When adjusting the eye mark on the rear surface, open the front cover and the bottom front cover. C Check the position of the last eye mark on the page printed before printing was stopped. D Press the Slow Feed switch or the Slow Rev.

Feed switch on the press to feed the substrate, and align the eye mark sensor light over the last eye mark on the page printed before printing was stopped. The last eye mark specified when reverse feeding 404