Fusing block The fourth part of the image formation process is the fusing block, in which the toner image is fused to the paper, making a permanent image that cannot be smeared. This block consists of one step: fusing. Step 9: Fusing This printer uses the induction heating method to fuse the toner to the paper. This method uses quick fuser heating, resulting in shortened wait time and reduced power consumption. Figure 5-26 illustrates this step. Figure 5-26 Fusing Cleaning block The fifth and final part of the image formation process is the cleaning block, in which the ETB and the photosensitive drums are cleaned, preparing them for the next print.
The next section provides more information about printer calibration and cleaning. This block consists of two steps: G ETB cleaning G photosensitive drum cleaning Step 10: ETB cleaning See page 120 for a complete discussion of ETB cleaning. Step 11: Photosensitive drum cleaning See page 121 for a complete discussion of photosensitive drum cleaning. 118 Image formation system C9660-90901