HP — Numerical printer messages

Table 7-3 Numerical printer messages (continued) C9660-90901 Chapter 7 Troubleshooting 231 Message Description Action 55.X PRINTER ERROR For help press alternates with 55.X PRINTER ERROR To continue press The DC controller is not communicating with the formatter. The problem could be caused by a timing error or an intermittent connection. 1 Press to continue. 2 Turn the printer off and then back on. 3 Reseat or replace the connectors between the DC controller and the formatter. 4 If the problem persists, replace the DC controller PCB. Calibrate the printer after replacing the DC controller. See “Calibrate Now” on page 294. 5 Replace the formatter. Initialize NVRAM.

See “NVRAM initialization” on page 293. 57.X PRINTER ERROR To continue turn off then on A printer fan error has occurred. X Description 3 cartridge fan (vertical fan, F2) 4 formatter fan (horizontal fan, F1) Turn the printer off and then back on. 57.3 Cartridge fan error (F2) 1 Reconnect the connector J1004 on the DC controller PCB. 2 Immediately after starting the print operation, measure the voltage between pins 1 and 3 on the J1004 connector. If the voltage changes from 0 V to 24 V, replace the cartridge fan. 3 Replace the DC controller PCB. Calibrate the printer after replacing the DC controller. See “Calibrate Now” on page 294.

57.4 Formatter fan error (F1) 1 Reconnect the connector J1003 on the DC controller PCB. 2 Immediately after turning the printer on, measure the voltage between pins 1 and 3 on the J1004 connector. If the voltage changes from 0 V to 24 V, replace the formatter fan. 3 Replace the DC controller PCB. Calibrate the printer after replacing the DC controller. See “Calibrate Now” on page 294. 58.X PRINTER ERROR For help press alternates with 58.X PRINTER ERROR To continue turn off then on A memory tag error was detected. X Description 3 CPU 4 power supply 1 Turn the printer off and then back on. 2 Replace the memory PCB. 3 Replace the DC controller PCB.

Calibrate the printer after replacing the DC controller. See “Calibrate Now” on page 294.