HP — Replacing the transfer unit

Replacing the transfer unit when it is not at end of life If you replace the transfer unit when it is not at the end of life, for instance if it is defective, you will need to calibrate the printer and reset the transfer unit count through the control panel. To calibrate the printer, do the following: 1 Press to enter the MENUS . 2 Press to highlight CONFIGURE DEVICE . 3 Press to select CONFIGURE DEVICE . 4 Press to highlight PRINT QUALITY . 5 Press to select PRINT QUALITY . 6 Press to highlight CALIBRATE NOW . 7 Press to select CALIBRATE NOW . 8 Wait for the printer to calibrate. To reset the transfer unit count, do the following: 1 Press to enter the MENUS .

2 Press to highlight CONFIGURE DEVICE . 3 Press to select CONFIGURE DEVICE . 4 Press to highlight RESETS . 5 Press to select RESETS . 6 Press to highlight RESET SUPPLIES . 7 Press to select RESET SUPPLIES . 8 Press to highlight NEW TRANSFER KIT . 9 Press to select NEW TRANSFER KIT . 10 Press to highlight YES . 11 Press to reset the transfer unit count. C9660-90901 Chapter 4 Printer maintenance 81