Department of Defense MIL-STD-1311D — MIL-STD-1311D Test Methods for Electron Tubes — DoD Standard Manual PDF

Downloaded from https://www.everyspec.com MIL-STD-1311D 2.2 Method B. 2.2.1 Test circuit. FIGURE 4253-3. Substitution method (high power). 2.2.2 Test circuit. FIGURE 4253-4. Substitution method (lower power). 2.2.3 Procedure. With the TUT inserted in the circuit shown on figure 4253-3 or 4253-4, the attenuator is adjusted to give a convenient power measurement with the switches in position 1. The switches are then changed to position 2, and the attenuator is readjusted to give the same power measurement as obtained with the switches in position 1. The gain of the TUT is the difference between the two attenuator readings. 2.2.4 Precautions.

2.2.4.1 In some cases the VSWR presented to the source by the TUT and by the by-pass circuit may be different. The source shall be sufficiently well decoupled to prevent changes in incident power in the two cases. 2.2.4.2 The loss in the by-pass circuit including mismatch at either end shall be included in the gain calculation. 2.2.4.3 In the case of high-gain broadband amplifiers, the broadband noise power output of the TUT may be of sufficient magnitude to affect significantly the results obtained with these test methods. Spurious output signals can also be of significant magnitude. Simple subtractions of the noise or spurious contributions can give an incorrect answer.

In these cases band limiting filters should be used ahead of power indicating devices. METHOD 4253 4253-2 19 April 1968