Department of Defense MIL-STD-1311D — MIL-STD-1311D Test Methods for Electron Tubes — DoD Standard Manual PDF

Downloaded from https://www.everyspec.com MIL-STD-1311D 7.2 Procedure. Measurements shall be made on a single frequency point by point basis. Attenuator A sets the operating rf level. The standing wave introducer is adjusted to produce a known reflection coefficient K T . A maximum power reading, Rmax, and a minimum power reading Rmin, are obtained by movement of the standing wave introducer. The square root of min max R R , called "S", is used to compute the reflection coefficient of the output of the TUT, k A , as follows: )1 ( )1 ( + = S K S k T A To express the match in VSWR, the following equation shall be used: A k k VSWR + = 1 1 7.3 Precautions.

7.3.1 The VSWR of the standing-wave introducer shall not be greater than the maximum rated operating mismatch of the tube in order to prevent damage to the TUT. 7.3.2 In some cases the VSWR of the matched termination may be comparable with standing-wave introducer resulting in a variation of VSWR as the phase is changed. This error may be corrected by making the measurement twice, with the load shifted by a quarter wavelength, and taking the geometric mean of the two values. 7.3.3 The signal source shall be sufficiently decoupled from its load. 7.3.4 Hot input and output match may depend upon signal level because of tube non-linearity. A METHOD 4256 4256-4 19 April 1968