Department of Defense MIL-STD-1311D — MIL-STD-1311D Test Methods for Electron Tubes — DoD Standard Manual PDF

Downloaded from https://www.everyspec.com MIL-STD-1311D The following definitions are required: F = Specified frequency band. V = Tuning voltage swing required to cover F. V (max) = Maximum permissible value of V. ATS = Average tuning sensitivity, where ATS = V F MHz/volt. N = Number of equal segments into which F is divided for measurement purposes; measurements are made at the N + 1 spot frequencies separating the segments, including the end points. δ F = Width of one frequency segment. δ V = Voltage swing required to tune over one segment ( δ V may be distinguished by subscripts, for different segments). STS = Spot tuning sensitivity, where STS = V F δ δ .

Po = Power output at the center of a segment, taken as the average of the values at the two measurement points defining the segment. P/TSP = Power/tuning sensitivity parameter, where . ) (min F x density power imum STS ATS x Po TSP P = The TSS shall specify a minimum value of ATS, which will ensure that the tube can be tuned across the band with a swing no greater than V max, and a minimum value of P/TSP which will ensure the required power density in each segment, without placing unnecessary restrictions on Po and STS separately.

The values of N and δ F should be chosen so that the variations of power and tuning sensitivity are not large within one segment, for a typical tube of the type being tested, while N is no larger than necessary. 3.2 Test circuit. FIGURE 4277-3. Test circuit for power spectral characteristics. METHOD 4277A 4277-3 25 March 1970