Downloaded from https://www.everyspec.com MIL-STD-1311D PATTERN DISTORTION 1. Pattern distortion shall be specified in percent at a given percentage of the minimum useful scan of the tube. It shall include the total errors of the deflection defects of trace angle, keystone, pin cushion, and barreling. The method for testing for pattern distortion shall be as follows. 2. The test shall be made by means of a transparent overlay (such as a photographic film) on which are two concentric rectangles and two cross lines bisecting the rectangles and mutually perpendicular to their sides. The sizes of the two rectangles shall be computed as follows: a.
The size of the scan at which the determination of pattern distortion is to be made shall be computed by multiplying the dimension of the minimum useful scan of each axis by the percentage of scan at which the pattern distortion test is to be made. These shall be the dimensions of the inner rectangle. b. The dimensions of the inner rectangle shall be multiplied by the maximum allowable percentage of pattern distortion. Each side of the outer rectangle shall be displaced from the edge of the inner rectangle by this computed amount. Example: A cathode-ray tube has a minimum useful scan of 4.000 inches (101.6 mm) on 1D2 and 3.000 inches (76.2 mm) on 3D4.
Pattern distortion shall be less than 2 percent at 75 percent of useful scan. 75 percent x 4.00 inches = 3.00 inches, 75 percent x 3.00 inches = 2.25 inches Inner rectangle dimensions, therefore, are 3.00 inches x 2.25 inches. 2 percent x 3.00 inches = .060 inch, 2 percent x 2.25 inches = .045 inch Outer rectangle dimension are 3 + 2 (.060) = 3.12 inches by 2.25 + 2(.045) = 2.34 inches. 3. The overlay shall be fixed in position with respect to the tube face with the center of the rectangles at the center of the tube face and with a trace produced by the 1D2 deflection plates aligned with the cross line parallel with the 1D2 scan dimension of the overlay, and equal to it in length.
With balanced dc voltages on the 3D4 deflection plates, the trace shall be moved out alternately to both edges of the overlay pattern. At some given trace position, its entire length shall fall within the boundaries of the two rectangles. After the trace has been repositioned to the center of the tube, and without repositioning the overlay, a trace shall then be produced by the 3D4 deflection plates, and the above procedure repeated. If the trace fails to fall within the area between the inner and outer rectangles on any of the four sides of the overlay, the tube shall be rejected. METHOD 5103 METHOD 5103 5103-1 19 April 1968