Department of Defense MIL-STD-1311D — MIL-STD-1311D Test Methods for Electron Tubes — DoD Standard Manual PDF

Downloaded from https://www.everyspec.com MIL-STD-1311D Where: R is the anticipated limiting resolution of the tube in WRSL/SSRD. J is the read scan-line length as a fraction of the SSRD. D is the active read scan-line duration in microseconds. SSRD is the storage surface reference dimension as determined by method 5405. WRSL is the written raster scan line. (It is acceptable to compensate for bandwidth limitations of the amplifier by reducing the reading raster width (J) provided the signal decay time is as specified in the TSS.) 4. Procedure. a. General. (1) Operating conditions shall be as specified in the TSS.

(2) The size of a blemish shall be measured between the blemish 50-percent amplitude levels and expressed as a percentage of the SSRD. (3) The oscilloscope line-selector and CRT display shall be used to determine the location of blemishes. (4) Both writing and reading focus shall be optimized to give highest resolution at the area being inspected for blemishes. (5) Unless otherwise specified in the TSS, the diameter of elongated blemishes shall be taken as half the sum of the length and width. b. Static-light blemishes. Static-light blemishes shall be observed under the specified test conditions in the absence of writing.

The amplitude of the blemish signals with respect to the saturated signal level ( % 100 x A B of figure 5408-1) and the sizes and spacing of the blemishes with respect to the SSRD shall be observed. c. Static-dark blemishes. Static-dark blemishes shall be observed with the entire storage surface written to a given percentage of the saturation level ( % 100 x A D on figure 5408-2). Unless otherwise specified in the TSS, this shall be 50 percent. The amplitudes of the blemish signals ( % 100 x D C on figure 5408-2) and the sizes and spacing of the blemishes with respect to the SSRD shall be observed. d. Dynamic blemishes.

Dynamic blemishes shall be observed with the entire storage surface written to a given percentage of the saturation level ( % 100 x A D on figure 5408-2). Unless otherwise specified in the TSS, this shall be 90 percent. The erasing rate, if dynamic erasure is used, and decay time shall be as specified. At a specified time after writing, the blemishes shall be observed. The amplitudes of the blemish signals ( % 100 x D C on figure 5408-2), the polarity of the blemish signals (light or dark), and the sizes and spacing of the blemishes with respect to the SSRD shall be observed. METHOD 5408A 5408-2 12 December 1972