Downloaded from https://www.everyspec.com MIL-STD-1311D 5. TSS requirements. a. In addition to the operating conditions for the TUT, the TSS shall specify the following for this test: (1) The maximum number of blemishes allowed in each blemish category. (2) The blemish amplitude limit(s). (3) The minimum blemish spacing. (4) The erase conditions and decay time for dynamic blemish inspection. (5) The time interval between writing and the dynamic blemish inspection. b. If values other than those specified in this test method are required, the TSS shall specify: (1) Separate size limit(s) for elongated blemishes.
(2) Writing level, as a percentage of saturation, for static-dark blemish inspection. (3) Writing level, as a percentage of saturation, for dynamic-blemish inspection. FIGURE 5408-1. Light blemish. FIGURE 5408-2. Dark blemish. METHOD 5408A 5408-3 12 December 1972