Downloaded from https://www.everyspec.com MIL-STD-1311D RESOLUTION, ELECTRICAL OUTPUT METHOD 5410 (Cathode-ray charge storage tubes) 1. Purpose. The purpose of this test is to measure the quantity of information that may be written in and read out of a storage tube. 2. Equipment. a. The writing-deflection system shall produce a raster of essentially parallel equally-spaced lines written at the sweep speed(s) and at the frame rate(s) as specified in the TSS. The spacing between the lines shall be adjustable. b.
The reading-deflection system shall produce a rectilinear (e.g., TV) type raster with lines disposed essentially orthogonal to the written lines, and repeated at a rate as specified in the TSS. c. External focus and deflection components when used shall be located with respect to the TUT as specified in the TSS. d. The output-signal amplifier shall be linear, compensated for the output impedance of the TUT, and have a frequency response that is flat within 1 dB between frequencies (f 1 ) and (f 2 ), to insure accurate reproduction of the output signal from the TUT. f 1 = the read scan-line repetition rate (Hz) f 2 = D RJ (MHz). Where:
R is the anticipated limiting resolution of the TUT in WRSL/SSRD. J is the read scan-line length as a fraction of the SSRD. D is the active read scan-line duration in microseconds. SSRD is storage surface reference dimensions determined by method 5405. WRSL is the written raster scan line. (It is acceptable to compensate by bandwidth limitations of the amplifier by reducing the reading raster width (J), or by reducing the angle between the reading and writing scan directions.) e. The storage tube's output shall be monitored visually on a raster type (e.g., TV) display, scanned in synchronism with the reading scan; and on an oscilloscope. 3. Procedure.
Resolution may be determined by either of the following methods: 3.1 Orthogonal write-read test method. a. Operating voltages and conditions shall be within the limits specified in the TSS. b. Adjust operating conditions so that visual representation of the entire storage target is seen on the raster type display. c. Adjust writing conditions to produce and establish write saturation level. Writing raster lines shall be spaced such that there is no discernible overlap. d. Adjust writing beam current to obtain the percentage of saturation specified in the TSS. METHOD 5410 5410-1 12 December 1972