Downloaded from https://www.everyspec.com MIL-STD-1311D WRITING AND ERASING RESPONSE, DYNAMIC, VISUAL OUTPUT METHOD 5417 (Cathode-ray charge storage tube) 1. Purpose. The purpose of this test is to measure the dynamic writing and erasing response of a visual output cathode-ray charge storage tube at specified conditions of luminance, writing-gun grid drive, and scanning speed, while simultaneously erasing to the background luminance level. This test method is intended primarily for tubes used in radar display applications. 2. Equipment. a.
A photometer shall be used to measure the luminance of the TUT over a circular area 10 ± 5 mm (approximately .4 ± .2 inch) in diameter, or as specified in the TSS. The photometer shall have a response time less than 0.1 second. (Such a characteristic could be achieved through the use of a peak holding device coupled to a fast response light sensor.) b. The deflection system shall produce a linear sawtooth line sweep at a rate of .016 inch (0.41 mm) per microsecond or as specified in the TSS. The frame and line periods shall be no greater than 125 percent of the resulting sweep times, or as specified in the TSS. (For example: with a 4-inch x 4-inch (101.6 mm x 101.6 mm) raster:
Frame-sweep time = 2 seconds Frame period = 2.5 seconds, maximum Line-sweep time = 250 µ s Line period = 312.5 µ s, maximum.) c. The writing control circuits shall be adjustable, but once adjusted for this test shall maintain a constant unblanking level during the active portions of the write cycles. d. A random generator shall provide a white gaussian noise signal with a bandwidth approximately 20 Hz to 500 kHz or as specified in the TSS, at an amplitude specified in the TSS. 3. Procedure. a. Operating conditions shall be as specified in the TSS. b. Without simultaneously erasing, write the entire area specified in the TSS to saturation level (without noise signal applied.) c. Stop writing.
Use the erase pulse width and frequency within the ranges specified in the TSS. Slowly increase the erase pulse amplitude until the last portion of the specified area has just been erased within the frame period or as specified in the TSS. d. Using the noise signal (V) within the specified limit(s), adjust the unblanking pulse, erase duty cycle, and erase amplitude within specified limit(s) to achieve a stabilized writing and erasing cycle whereby: (1) The slowest erasing portion of the specified area is completely erased immediately prior to being rewritten. (2) The noise signal is writing to the peak luminance level specified in the TSS.
(3) The unblanking level is adjusted just below the point at which storing would occur in the absence of the noise signal. (4) The display uniformity is optimized. NOTE: The stability of the writing and erasing cycle shall be verified by observation over a period of 2 minutes or as specified in the TSS. METHOD 5417 5417-1 12 December 1972