Department of Defense MIL-STD-1311D — MIL-STD-1311D Test Methods for Electron Tubes — DoD Standard Manual PDF

Downloaded from https://www.everyspec.com MIL-STD-1311D 5. Precautions. 5.1 The TSS shall clearly indicate all operating conditions and electrode potentials during the reading time. The output signal amplitude at the beginning of the reading time interval (I S (O)), shall be specified. 5.2 This method is not applicable to tubes operating in a bistable mode. FIGURE 5421-1. Oscilloscope trace of output signal for a single line scan through the center of the fastest decaying region. 6. TSS requirements. a. In addition to the operating conditions for the TUT, the TSS shall specify the following: (1) Area(s) of target in which reading time is to be determined.

(2) Output signal current (I S (O)) at beginning of reading time interval. b. If values other than those specified in this test method are required, the TSS shall specify: Residual output signal after elapsed reading time interval (T R ) if different from 50 percent. METHOD 5421 5421-2 12 December 1972