.+:. , ..l , MIL-STE-81OB . ,.., 15 June 1967 ., ,- RC > 0.2 Downloaded from https://www.everyspec.com Where R . load resistance (ohms) C = accelerometer,capacitanceplus shunt capaciteace .’., ... of cable end load (farads) 2,2.3 Accelerometer,strain gage. - A strain gage accelerometermay be used, provided the undampednatural frequency is equal to or greater than 1,500 cps with damping approximately0.64 to 0.70 of critical, 2,2.4 Accelerometercalibration.- The accelerometershall be dynamicallycali- I brated to the specifiedaccuracy, I 2.2.5 Accelerometermountin&.
- The monitoring accelerometershall be rigialy attached to the test item support fixture at or near the attachmentpoint(s) of the test item. 3. Procedures.- 3.1 :hcck P$se. - The shock pulses for Procedures 1, 111, and Iiishall be as I shown on f~g~e 51 .1-1 or 516.1-2 (whichever is specified). W1 points of the ac.:eier- ation waveform o“nrainedshall lie within the area enclosed by the tolerance limit lines, ~ it is reccmunendedthat the saw tooth shock pulse be used, since its broad freqzency spectrum tends to exzite all resonant frequencies. .3.2 Mounting of test item.
- The test item shall be rigidly attached to the sho:k hachine table for Procedures 1, III, and IV, in accordancewith 8ection 3, Oeneral Requirements,paragraph 3.2.2. Wherever pos b..ble, the test load shall be distributeduniformly on the test platform in order to minimize the effects of unbalanced loads. (r 3.3 Procedure I. Basic desian test. - This procedure shali be used for shzck testing of equipment assemblies (mechanical,electrical,hydraulic,electronic,etc.) of medium size, including item which mount on vibration isolatorsand equipmentracks. Three shocks in each direction shall be applied along three mutually perpendicularaxes of the test iten (total of 18 shocks).
If the test item is normally mounted on vibra- tion Isolators,the isolators shall be functicnml during the test. The shock pulse shape shall k-ein accordance vith either figure 516.1-1or 516.1-2, of amplitudea or b and time duration c or d, as specified. The test item shall be operating during the test if requiredby the equipment specificaticm. At the conclusionof the te@,, the test item shall be operated and the results compared with the data obtained in accord- ance with section 3, General Requirements,paragraph 3,2.1. The test item shall then be inspected as specified in.section 3, Ceneral Requirements,paragraph 3.2.k. ,. 3.k Procedure II. Transit drop test.
- 3.4.1 purpose.- Thisprwedure shall be used for equip~nt, in Its transit or combination case as prepared for field use, to determine if the equipment is capable of withstandingthe shocks normally induced by loading and unloading of equipment. (This is not the logistics ehfppirg nvironment experiencedby chipping containers.) METROD 516.1 20 October 1969 516.1-2 ....-’