MIL-STD MIL-STD-810B Method 513.1 / 514.1 — MIL-STD-810B Method 513.1 Acceleration & 514.1 Vibration Test Standard PDF

. :,.” ,.;,, ;,:,:::; , ,, ,. .. ( .. Downloaded from https://www.everyspec.com . . 3.~,2 Test conditions.- The test item shall be in its transit or combination case. For equipment 1,000 pounds or lesa, the floor or barrier receivingthe impact shall be of solid, 2 inchesthick, plywood backed by either concrete”or,a rigid steel frame, For eq,ilpmentover 1,000 pounds, the floor or barrier sh?ll be concrete or its equivalent. 3.b.3 Performance”of test. - Subject the test item to the number end heights of drop as required in table 516.1-1. Upon completion of the test, the test item shall be operatedand the results compared with the data obtainedin accordancewith section 3.

GeneralRequirements,para~aph 3.2.1. The test item shall then be inspected aa specifiedin section 3, General Requirements, paragraph 3.2.b. TABTLE516.1-I. Transit drop test (Prxedure II) Weight of test item Largest dimensions Heightof and case (inches) h’otes &OD (h. ) Under 100 pwrxks Under 36 A 48 man-pa-ledand man-p~rtable No.

o f &0 p 8 Drop on each face, edge, and coiner ?6 and over A 30 100 to 20?Ipcunds, Under 36 A 30 inclusive Total of 26 dl’OpS 36 and over A 24 @er 200 to 1,000 under 36 A 24 pounds,inclusive Drop on each corner 36 to 60 B 36 Total of 8 dl’OpS (-- Over 60 B 24 Cver 1,000 pounds No limit c 18 4 edgewise drops 2 cornerwisedrops Iio:eA, Erops shall be made from a quick-releasehook; or drop tester as ua~e by the L.A.B. Corporaticm,Skaneateles, New York, or equal.. The test item shall be oriented so that upon impact a line from the stmck corner or edge to the center of gravity of the case and contents is perpendicularto the impact surface. .. .

With the longestdimension pe.rallelto the floor, the tram it or combination case, with the test Item within, shall be supportedat the cornerof one end by a block 5 inches in heiuht. and at the other corner or ede of the same e~d by ,*block 12 inches i; height. The oppositee~d O? the-c~e ‘shallthen be raised to the specified height at the lowestunsupported corner:and,. allowed to fall freely. . . . . ;-..-.’ i.=.Z+.ZF.*..-~. ... &. .. . .. .. ......... >>W, , %$Q:.

kile in the ‘rio~ transit position,“the case hd contents shall :be sub- jected to the e~ewise end cornerwise drop test as follows (If normal transit position Is unknown,the case shall be oriented such that the tvo longest dimensionsare parallel to the “floor”): Note B, . . . :..-.. I I?ote C. ---- . >:? Z.WI. .f,,.:=*; ~vf![F. . 516.1-3 MFEiOD 516,1. : ! . i i ,. . ~~20.October’1969’”’. -.. f.,%. ..... ...4.?,, .- . .. ., .. . . . . ...” ..- ... .; ., I .., ~ ,,, ,