Appendices A-4-2 Soldering 1 Sheathe each wire with a heat shrinkable tube. 2 Place some standby soldering tin on each wire and each pin of the connector. 3 Solder each wire and each pin of the connector. 1mm Soldering iron Heat-shrinkable tube Inside diameter:1.5 Length=10 4 Pull the heat shrinkable tubes back to the soldering parts, heat them with a heat shrinking gun to make them shrink. Heat-shrinkable tube A-4-3 Shield Assembly Assemble the connector shield as shown below. Aluminum Foil Tape The end connected to the connector The end not connected to the connector A-10 NB-series Programmable Terminals Setup Manual(V107)