Nucleo GX Manual 5.3. VE.Can Devices To connect a product with a VE.Can port, use a standard RJ45 UTP cable (available with straight and elbow connectors). Important: Terminate the VE.Can network at both ends using VE.Can terminator . A bag with two terminators is included with each VE.Can product. Additional terminators are available separately . Compatibility notes The MPPT 150/70 must be running firmware v2.00 or newer to function with GX devices A Skylla-i control panel and an Ion Control panel can be used together with GX devices All VE.Can devices provide power to the VE.Can network, so no separate VE.Can power supply is required Protocol converters (e.g.
VE.Bus to VE.Can interface, BMV to VE.Can interface) do not power the VE.Can network VictronConnect-Remote (VC-R) support The following VE.Can products support VictronConnect-Remote (VC-R), enabling configuration and monitoring via VRM. For more details, refer to the VictronConnect manual . 5.4. VE.Can Interfaces The Nucleo GX has two fully functional VE.Can ports. They are independent from a data and connected device perspective. One is labelled VE.Can 1 and is galvanically isolated, the other is labelled VE.Can 2 and is non-isolated. 2 Ч Fully configurable VE.Can ports (VE.Can 1 is isolated) Both ports can be set to:
VE.Can (250 kbit/s, default) BMS-Can (500 kbit/s) CAN-bus BMS (250 kbit/s) Other supported CAN profiles such as RV-C Usage guideline VE.Can (250 kbit/s, default) For Victron devices like: VE.Can MPPTs Skylla-IP65 Lynx Shunt VE.Can Terminate both ends using the included VE.Can terminators Lynx Smart BMS and Lynx Smart BMS NG BMS-Can (500 kbit/s) For managed lithium batteries (e.g.
BYD, Pylontech, Freedomwon) Terminate at the GX device with the included terminator Follow the battery manufacturer’s instructions for termination on the battery side Page 26 Connecting Victron products VE.Can product VC-R Remarks Lynx Shunt VE.Can Yes - Lynx Smart BMS, Lynx BMS NG Yes - Inverter RS, Multi RS and MPPT RS Yes They also have VE.Direct but must be connected via VE.Can for VC-R Blue/Smart Solar VE.Can MPPTs [1] Yes Tr and MC4 models Skylla-i and Skylla-IP44/-IP65 Yes Requires firmware v1.11 [1] All VE.Can solar chargers except the very old (big rectangular case with display) BlueSolar MPPT VE.Can 150/70 and 150/85