Orion-Tr Tr Smart DC-DC Charger Non-Isolated — 7.3.3. Battery is almost full

Orion-Tr Smart DC-DC Charger Non-Isolated 7.2.4. Engine shutdown is detected The has concluded from the input voltage that the engine is not running. If the engine is indeed off, this is correct behaviour and no action is needed. If the message appears while the engine is running, check the following: The start voltage is set too high for the alternator, so charging never starts. This typically happens when the wrong alternator type is selected: a smart alternator may never reach the start voltage of a regular alternator. Select the correct alternator type or adjust the start voltage; see Engine shutdown detection setup with VictronConnect [11] .

The shutdown voltage is set too high, so charging stops too early and the battery remains undercharged. Adjust the shutdown voltage; see Engine shutdown detection setup with VictronConnect [11] . The settings are correct, but the alternator voltage sags below the shutdown voltage as soon as charging starts. This is not a settings problem but a sign that the alternator cannot supply the required power; see Insufficient alternator power [20] . Some smart alternators legitimately operate at voltages too low for reliable engine shutdown detection.

In that case, use an external engine running signal instead of stretching the voltage settings; see the Using an external engine running signal [13] section. Once the battery is full, the will stop charging or greatly reduce the charge current. This is especially the case when at the same time the DC loads in the system are not consuming any power from the battery. 7.2.5. Battery is full Be aware that it may also be possible for the to think the battery is full when it is not. This can occur when the charge voltages have been set too low, causing the to switch to the absorption or float stage prematurely. 7.3.

Battery is undercharged This section deals with possible reasons why the is not sufficiently charging the batteries and the steps you can take to check or remedy the situation. Some signs of undercharged batteries: The battery takes too long to charge (> 10hrs). The batteries are not fully charged at the end of the charge cycle. The charge current from the is less than expected. 7.3.1. Too much DC load The battery will only be charged when the power available exceeds the power being drawn by the loads in the system, like lights, fridge, inverter, and so on. The not only charges the batteries but also provides power for the system’s loads.

If the system battery monitor is correctly installed and configured, you can see how much current is going in (or out) of the battery. A positive reading means that current is flowing into the battery, while a negative reading indicates that current is being drawn from the battery. Turn off all loads and try again to rule this out. 7.3.2. Battery charge voltages are too low Check if the battery charge voltages (absorption and float) are set correctly. Consult the battery manufacturer’s information for the correct charge voltages. If the battery voltages have been set too low, the batteries will not receive a full charge. 7.3.3.

Battery is almost full The will reduce its charge current when the battery is almost full. If the battery's state of charge is unknown, and the current is reducing while the engine is running, it can mistakenly be interpreted as the being faulty. The first current reduction takes place during the absorption stage. During the absorption phase, when the battery is almost full, the current is further reduced gradually. The float stage starts when the batteries are full. During the float stage the charge current is very low. Page 19 Troubleshooting & Support