Super Micro Computer, Inc. PDSMA+ / PDSMA-E+ — Super Micro PDSMA+ / PDSMA-E+ User Manual: Motherboard Guide PDF

Chapter 2: Installation CMOS Clear JBT1 is used to clear CMOS. Instead of pins, this "jumper" consists of contact pads to prevent accidental clearing of CMOS. To clear CMOS, use a metal ob- ject such as a small screwdriver to touch both pads at the same time to short the connection. Always remove the AC power cord from the system before clearing CMOS. Note: For an ATX power supply, you must completely shut down the system, remove the AC power cord and then short JBT1 to clear CMOS. Do not use the PW_ON connector to clear CMOS. VGA Enable/Disable JPG1 enables or disables the VGA Con- nector on the motherboard. See the table on the right for jumper settings. The default setting is enabled.

USB 1/2 KB/MS COM1 JPG1 B (CPUFan) Fan6 DIMM 1A VGA JLAN1 North Bridge CPU Intel 3010 OR Intel 3000 Fan2 A. Clear CMOS B. VGA Enabled JLAN2 LGA 775 L R T C P F Fan5 PCI-Exp.

x8 JPF JWD IPMI 2.0 JLED Fan3 S A+/PDSMA-E+ M S D P R E P U LAN1 CTRL PCI-X 64-bit 133 MHz PCI 32-bit 33 MHz JI2C1 JI2C2 PXH-V LAN2 CTRL JPL1 JPL2 PCI 32-bit 33 MHz PCI 32-bit 33 MHz ® S I/O PCI 32-bit 33 MHz Printer L E 3 L E 4 South Bridge ICH7R COM2 Floppy PCI 32-bit 33 MHz J9 WOL SPKR JBT1 USB3/4 USB5/6 JP3 JWOR JL1 A LE1 SATA0 SATA1 SATA3 2-23 VGA Enable/Disable Jumper Settings Jumper Setting Definition Pins 1-2 Enabled Pins 2-3 Disabled 4 PW 3 PW JPR1 8-pin PWR 2 R PW ATX 4-Pin VGA CTRL DIMM 2B DIMM 1B Fan1 BIOS 1 *Compact Flash only n4 Primary IDE