Chapter 2: Installation Compact Flash Master/Slave Select A Compact Flash Master (Primary)/ Slave (Secondary) Select Jumper is located at JP3. Close this jumper to enable Compact Flash Card. For the Compact Flash Card to work properly, you will need to connect the Compact Flash Card power cable to JWF1 and close this jumper to enable it first. Refer to the board layout below for the location. I 2 C Bus to PCI-X/PCI-Exp. Slots Jumpers JI 2 C1 and JI 2 C1 allow you to connect the System Management Bus (I 2 C) to PCI-X/PCI-E slots . The default setting is "Open" to disable the con- nection. See the table on the right for jumper settings. USB 1/2 KB/MS CTRL VGA VGA COM1 JPG1 Fan6 Intel 3000 A.
Compact Flash Select B. I 2 C1 JLAN1 North Bridge CPU LGA 775 Intel 3010 OR Fan2 C. I 2 C2 JLAN2 Fan5 JWD JLED Fan3 L R T C P F S A+/PDSMA-E+ M S D P R E P U LAN1 CTRL PCI-X 64-bit 133 MHz PCI-Exp.
x8 JI2C1 JI2C2 C B JPF IPMI 2.0 LAN2 CTRL JPL1 PCI 32-bit 33 MHz PCI 32-bit 33 MHz PXH-V ® S I/O JPL2 PCI 32-bit 33 MHz PCI 32-bit 33 MHz L E 3 L E 4 South Bridge ICH7R COM2 Floppy PCI 32-bit 33 MHz Printer J9 WOL SPKR JBT1 USB3/4 USB5/6 JP3 JWOR JL1 A LE1 SATA0 SATA1 SATA3 2-25 Compact Flash Card Master/ Slave Select Jumper Definition Open Slave (Secondary) Closed Master (Primary) I2C to PCI-S/PCI/Exp Jumper Settings Jumper Setting Definition Closed Enabled Open Disabled (Default) 3 4PW PW JPR1 8-pin PWR 2 R PW ATX 4-Pin DIMM 2B DIMM 1B Fan1 BIOS 1 *Compact Flash only n4 Primary IDE