Mitsubishi — 6.3 Motion Instructions

6 Motion Instructions & G-Code Instructions MON 02 03 Operands: P 1 : Target position on X axis P 2 : Target position on Y axis P 3 : Target position on Z axis P 4 : Distance to the center of arc/helix on X axis P 5 : Distance to the center of arc/helix on Y axis P 6 : Distance to the center of arc/helix on Z axis V : Arc/helical interpolation speed Explanations: 1. P 4 , P 5 , P 6 : The vector-valued coordinate of center of arc or center of helix, i.e. distance to the center of arc/helix on X-Y-Z axes. 2. V MAX = 500kHz 3. Range of parameters P 1 , P 2 , P 3 , P 4 , P 5 , P 6 :

(16-bit) K = -32,768 ~ 32,767; H = 0 ~ FFFF; D = 0 ~ 9,999; (32-bit) KK = -2,147,483,648 ~ 2,147,483,647; HH = 0 ~ FFFFFFFF; DD = 0 ~ 9,998. 4. Acceleration/deceleration time and bias speed can be set up in special D. 5. Acceleration/deceleration time increases or decreases in proportional to the setting of V MAX . 6. Timing diagram: Speed T ACC T DEC V MAX Operation speed Start Time 7. 2-axis arc interpolation: 20D model only supports arc interpolation on X-Y plane. 20M model supports arc / helical interpolation on 3 planes by G-Code instructions: G17 (X-Y plane), G18 (X-Z plane) or G19 (Y-Z plane). See the figure below for X-Y arc interpolation.

DVP-PM Application Manual 6-12 Mnemonic Operands Function Controllers 20PM - CW / CCW X P Y P 1 2 Z P I P J P 3 4 5 K P F V 6 Clockwise Arc / Clockwise Helical / Counterclockwise Arc / Counterclockwise Helical Movement (distance to center of arc) Controllers 20PM - Type Bit Devices Double-Word Devices Notes K H D KK HH DD ƒ CW/CCW instruction supports V, Z index register modification on the devices. ƒ You can place an M-Code instruction after CW/CCW. P 1 * * * * * * P 2 * * * * * * P 3 * * * * * * P 4 * * * * * * P 5 * * * * * * P 6 * * * * * * V * * * * * * V BIAS