Mitsubishi — 6.3 Motion Instructions

6 Motion Instructions and G-Code Instructions Y CCW Starting point (current position) Center (I, J) CW Target point ( , ) X YP P 1 2 8. 3-axis helical interpolation: Applicable to 20M model only. 3-axis helical interpolation is an advanced function to X 2-axis arc interpolation. When a 3 rd axis is added to arc interpolation, a helical interpolation can be performed, i.e. if the vertical value on Z axis is set to 0, the helical interpolation will simply perform 2-axis arc interpolation. 9. The figure below illustrates the moving paths of the helical interpolation with and without the value on Z-axis.

(G17 mode, X-Y plane) Z Target point (x, y, z) Z Target point (x, y, z) Target point (x, y) Target point (x, y) Y Y Center (I, J) Center (I, J) Center (I, J) Center (I, J) X Starting point Starting point X Z=0 Starting point Z=0 Starting point Z=0 Z=0 CCW (counterclockwise) CW (clockwise) 10. The figure below illustrates the moving paths of the helical interpolation with and without the value on Y-axis. (G18 mode, X-Z plane) Z Z Target point (x, y, z) Target point (x, y, z) Starting point Center (I, K) Y Target point (x, z) Center (I, K) Y=0 Y Starting point S tarting point Y=0 X CCW (counterclockwise) CW (clockwise) X 11.

The figure below illustrates the moving paths of the helical interpolation with and without the value on X-axis. (G19 mode, Y-Z plane) DVP-PM Application Manual 6-13 rg nt , K Starting Center point (I, K) et point (x, z) Y er ) Tar ( =0 Y=0