9 Electrical CAM Control Steps: Step 1: Add 2 sets of E-CAM charts and set the resolution as 900. Step 2: Download the below program in DVP-20PM and execute. Step 3: Set M100 to write the parameters for rotary cut E-CAM into D100~D112 and CR#10000 into D0. In addition, write the data in D100~D112 into special register CR#10000 to generate the 1 st rotary cut E-CAM curve Step 4: Set M101 to change the data in D111. Write the modified data into special register CR#10000 to generate the 2 nd rotary cut E-CAM curve. Step 5: Set M102 to change the data in D102 and D111. Write the modified data into special register CR#10000 to generate the 3 rd rotary cut E-CAM curve. Step 6:
Stop the DVP-PM and upload the program. Step 7: Monitor the uploaded E-CAM Chart-0, which is the generated multi-cutter E-CAM curves. Ladder Diagram: DVP-PM Application Manual 9-44 CAM curve 0 0 0 CAM curve setting Only single data real-time modification is applicable Borrow the previous E-CAM data setting Borrow the previous E-CAM data setting Results 0 0 0